Bonnet INO 36 Specifications download pdf (Page 9)

INO 36 DISHWASHER Code NU271700-11/97-Ind.B-01/99

Chap.5 - Page 1

SERVICE - SERVICE - SERVICE - SERVICE - SERVICE - SERVICE -

To ensure the guarantee of this equipment, you must carry out the following service operations :

* End of operation (2nd part)

_____________________________________________________________

* Cut off the electric power * Close the water supply * Check the levels of the containers of :

at the main circuit-breaker. - rinse product

- detergent (exterior appliance)

- regenerating salts (option).

Complete if necessary

* Let the door open to favour the drying of the

dishwasher.

* Access to the rinse product meter and regenerating salts vat (option)

- Rinse meter : located behind the front lower panel.

- Regenerating salts vat(interior tank)

* Rinse product meter operation :

The meter flowrate setting is made by using

the meter setting screw.

* First setting according to the manufacturer indications.

Correct if necessary according to the results obtained on the crockery.

Surface-active product meter is

set in factory. It is possible to

modify the setting by removing the

lower cover.

- Screw to reduce the injected quantity.

- Unscrew to increase the injected quantity.

WARNING : never screw or unscrew at the

maximum.

* If the rinse product container is completely empty

prime again the meter after filling.

- Prime the metering system (control panel) by starting very short wash cycles every 10" to 15".

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 20 21

No comments

Bonnet INO 36 Specifications Page 9